Homemade Helicopter Collective? Yes please!


#1

This is quite nice. Homemade and looking like a quality unit!

Trawlled off of reddit.


#2

Pulling for power…


#3

WANT


#4

Starting to think about my Huey collective project again…
Does anyone know of any good designs regarding collective friction?
Other than this gem of a document
http://damienstpierre.com/blog/?page_id=337
I’m borrowing from this design and my own concept


I’m not happy with my base design and wish to improve the friction lock (not visible in this version illustrated above)
I also need to revamp the head as it’s overly and unnecessarily complicated


#5

Good you dug this tread.

I actualy made ’ some kind ’ of DIY colective out of TM 16k joy. Nothing to go to public with :slight_smile: , its an early prototype, but it serves its purpose…

:wink:

In fact, creation of almost ’ DIY ’ colective is easy I would say. You just need CH Pro Thortle ( or other sliding throtle ) and some kind of side mount to ofice chair.
If you mount Pro Throtle on a side of a chair - bottom of it facing to the side of chair and front of it facing to the floor. Then it can serve as a colective - pushing will results in travel to the floor and pulling in up travel.

Thats why the throtle action in XP is by default reversed for helos. Hopefully, nobody is pulling for power with desk throtle :wink:


#6

I pull for power at my desk. Always have!

(That is until I starting pulling thin air using the VR touch controller.)


#7

Nevo…GET OUT OF MY HEAD…dude you’re creeping me out!
:fearful:
my first sim-pit design (the mark 1 - I called it)
i had my old TM-TQS where i could mount it to the side wall vertically like a collective,
but because the TQS had that arcing throttle action, i didn’t like it as much and I would enviously salivate at the straight sliding action of the CH pro throttle… that’s what i wanted ( but couldn’t justify another controller)
for me it was easy to mount on the side of the sim-pit, but for guys with office/swivel chairs, not as attractive, as bumping and potentially damaging the controller was a consideration.

FYI (& my only claim to fame) my Mk II cockpit was the design that inspired the “Akers-Barnes” cockpit, which Michael and Peter actually credited me for in their original web page (very humbling).
Back then I couldn’t use CAD and didn’t bother producing workable plans


#8

DIY colective… in progres :slight_smile:

Just checked the above link of Damien page and he is actualy right, two pilow block bearings are necesary. One ( bearing ) causes side wigle of the colective handle


#9

Few pics of my ’ quick n easy ’ prototype while I am waiting for the bearings to be delivered.

Electronics is MaRS sensor from COBRA M5 joy. One axis already used for the ruder pedals. This is the second axis.

No friction, no grip yet, just contra weight…


#10

some progres