Prints are finished!
A bunch of twisted parts…
Yes, the printer can switch filament during the print, so it would be possible to print the whole handle in one go. I will probably try that too, even if it’s a 16h print. The switching of the filaments takes about half a minute and is done for every layer, so about 11 hours of the print is filament switching.
So for now, I print the handle in parts, with yellow and black overlapping. I could also try printing the different colors as single, separate pieces, and see how that goes…
They actually click into place rather well!
I will try glueing with a flexible CA glue to see how that holds up.
